Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Mines question
#1
The mines, do they do full dmg on 300 range and half dmg on 600 range or is it that the dmg varies from 0 to 600 range doing full damage on 0 range and 50% on 600 range? Just had a discussion about it and would really like to know nowSmile
Reply
#2
Code:
        if Dist <= 0.5 * Rng then
            set Damage = Dmg
        else
            set Damage = (1.75-1.5*(Dist/Rng)) * Dmg

Dist = Distance between the triggering unit and the mine
Rng = the maximum range of the mine (in this case its 600)
Dmg = the mine damage, depends on the mine and attack upgrades

It does basically mean that full damage is dealt within half the range (300), after that the damage slowly goes down to 25% of the maximum. So at 301 range its just slightly lower than the full damage.
This post has been brought to you by Sand - it's everywhere, get used to it.
Reply
#3
Ok thank you for this information, seems i was more right then the other guyTongue
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  question about Kinetic Shield stibi- 4 5,822 2014-05-16, 21:41:52
Last Post: stibi-
  Clarify tooltips of armors / Question about weapon damage griffin1987 1 2,690 2014-03-01, 17:12:43
Last Post: Exodus
  Assist Mines PaPPa_D 0 2,032 2011-07-31, 09:38:55
Last Post: PaPPa_D
  Does remove fuse suck hard? Or the hulls pwn mines better? TKF 12 8,024 2009-11-21, 22:43:03
Last Post: IlPalazzo
  disable putting wards, mines and factories in enemy base benben10 17 9,208 2009-05-04, 22:30:30
Last Post: Tynkywinky



Users browsing this thread: 4 Guest(s)